If the material roll is relatively large or heavy and does not move during the printing and output of the large format printer, it will affect the screen, and horizontal stripes will appear on the screen, which will also make the material walking size non-standard. If this happens You can open the material to make the cloth travel evenly, and at the same time, pay attention to the two paper presses to ensure that the paper feeds normally during the printout process.

Since the printer is sensitive to static electricity during the printing and printing output process, the ground wire of the equipment should be handled under the guidance of the installer. When printing, pay attention to connecting the ground wire to prevent static electricity from causing unknown printing problems.

Pay attention to the influence of temperature and humidity in the use environment of the large format printer, avoid excessively humid or dry environment, pay attention to the surface of the machine, clean the surface of the machine in time, remove debris, shredded paper, residual ink, etc.

The parameter settings of the large format printer contacting the computer system cannot be changed arbitrarily, especially the settings of the online IP address, the installation of the driver, and the addition of Montai Printing.

Note that the motor cannot push the trolley when it is energized, otherwise it will easily cause various dislocations; if the trolley is too noisy when it is walking, check the wear and tear of the slider to see if there is any problem.

Regularly check the wear condition of the data transmission cable in the drag chain to ensure that there is no open circuit, short circuit and signal interference. Whether the data line of the machine and the computer is in good contact, for example, the network cable of the network port photo machine is in good contact with the computer network card.

Pay attention to the storage of printing consumables, such as ink storage and sealed storage, and moisture-proof printing paper materials.

Pay attention to the daily maintenance of the nozzles, especially for outdoor oil-based ink printers. It is recommended to print once a day to avoid the ink clogging of the nozzles that may be caused by stopping printing for a long time. Do a good job of cleaning and maintaining the nozzles and moisturizing the ink stack.